Optional Idsdm Or Vflash Module; Removing Idsdm Or Vflash Module - Dell EMC PowerEdge R840 Installation And Service Manual

Figure 69. Installing a processor and 2U heat sink module
Next steps
1 Install the air shroud.
2 Follow the procedure listed in

Optional IDSDM or vFlash module

The IDSDM or vFlash module combines the IDSDM and/or vFlash features into a single module.
NOTE: The write-protect switch is on the IDSDM or vFlash module.

Removing IDSDM or vFlash module

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
4 Remove the expansion card riser
Steps
1 Locate the IDSDM or vFlash connector on riser 1.
2 Holding the pull tab, lift the IDSDM or vFlash module out of the system.
After working inside your system
Safety instructions.
Before working inside your
1.
system.
Installing and removing system components 103