Optional Idsdm Or Vflash Module; Removing The Microsd Card - Dell EMC PowerEdge R940xa Installation And Service Manual

Figure 99. Installing the M.2 BOSS module
Next steps
1. Replace the BOSS card.
NOTE: Replacing the BOSS card is similar to the procedure for installing an expansion card.
2. Replace the expansion card
3. Replace the air shrouds.
4. Replace the support bar.
5. Follow the procedure listed in

Optional IDSDM or vFlash module

NOTE: The write-protect switch is on the IDSDM or vFlash module.

Removing the MicroSD card

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the support bar.
4. Remove the air shrouds.
5. Remove the expansion card
6. Remove the IDSDM or vFlash
Steps
1. Locate the MicroSD card slot on the IDSDM or vFlash module, and press the card to partially release it from the slot.
NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal.
2. Hold the MicroSD card and remove it from the slot.
132 Installing and removing system components
riser.
After working inside your
Safety instructions.
Before working inside your
riser.
module.
system.
system.