8
Remove the system
cover.
9
Remove the air
shroud.
10
Remove the BOSS
card.
NOTE:
The procedure to remove the BOSS card is similar to the removing an expansion card.
Steps
1
Insert the M.2 SSD module at an angle into the BOSS card connector.
2
Push the other end of the M.2 SSD module until it rests on the stand off on the BOSS card.
3
Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS card with the screw.
Figure 107. Installing the M.2 SSD module
Next steps
1
Install the BOSS
card.
NOTE:
The procedure to install the BOSS card is similar to the installing an expansion card on the system board.
2
Install the air
shroud.
3
Install
the system
cover.
4
Place the system into the rack. For more information, see the Rail Installation Guide available at www.dell.com/poweredgemanuals.
5
Open the drive
bays, install
6
Install the
power supply
7
Follow the procedure listed in
Optional IDSDM / vFlash module
The write-protect switch is on the IDSDM module.
all
drives, and then
close the drive bays.
units.
After working inside your
system.
Installing and removing system components
133