Figure 82. Installing the M.2 SSD module
Next steps
1
Install the BOSS card.
NOTE:
Installing the BOSS card is similar to installing the expansion card riser.
2
Install the air
shroud.
3
Follow the procedure listed in
Optional IDSDM or vFlash module
Removing the MicroSD card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Steps
1
Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate IDSDM/
vFlash module, see the
2
Hold the MicroSD card and remove it from the slot.
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
Next step
1
Install a MicroSD card.
136
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
System board jumpers and connectors
system.
system.
section.