Figure 89. Installing the expansion card riser
Next steps
1.
Replace the expansion card
2.
Replace the air
shrouds.
3.
Replace the support bar
4. Follow the procedure listed in
Removing the expansion card from the system board
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the support
bar.
4.
Remove the air
shrouds.
5.
Remove the expansion card
6. If applicable, disconnect the cables connected to the expansion card.
Steps
1. Press the card retention latch and open it.
2. Hold the expansion card by its edge, and lift the expansion card until the card edge connector disengages from the connector on the
system board.
3. Lift the expansion card out of the system.
122
Installing and removing system components
riser.
After working inside your
Safety
instructions.
Before working inside your
riser.
system.
system.