Installation Of Cp6500-V Peripheral Devices - Kontron CP6500-V User Manual

CP6500-V
8. Obtain the replacement CP6500-V board.
Warning!
When performing the next step, DO NOT push the board into the back-
plane connectors. Use the ejector handles to seat the board into the back-
plane connectors.
9. Carefully insert the "new" board into the "old" board slot until it makes contact with the
backplane connectors.
10. Using both ejector handles, engage the board with the backplane. When the ejector han-
dles are locked, the board is engaged.
11. Fasten the front panel retaining screws.
12. Connect all required interfacing cables to the board. Hot swap of the CP6500-V is now
complete.
3.5

Installation of CP6500-V Peripheral Devices

The CP6500-V is designed to accommodate a variety of peripheral devices whose installation
varies considerably. The following chapters provide information regarding installation aspects
and not detailed procedures.
3.5.1 CompactFlash Installation
The CompactFlash socket supports CompactFlash ATA cards type I and II with 5 V (default) or
3.3 V.
Note ...
The CP6500-V does not support removal and reinsertion of the CompactFlash
storage card while the board is in a powered-up state. Connecting the Com-
pactFlash cards while the power is on, which is known as "hot plugging", may
damage your system.
3.5.2 USB Device Installation
The CP6500-V supports all USB Plug and Play computer peripherals (e.g. keyboard, mouse,
printer, etc.).
Note ...
All USB devices may be connected or removed while the host or other
peripherals are powered up.
ID 28945, Rev. 01 © 2005 Kontron Modular Computers GmbH
Installation
Page 3 - 7