Table of Contents
Advertisement
3.
HARDWARE INSTALLATION
The Panel of this type is developed to work in a control cabinet. Thereby it must
be pointed that all the environmental conditions must be considered.
When installing the Panel take care that there is enough area for ventilations on
rear side. For details go to item housing dimensions.
If your Panel was delivered without software install a keyboard and mouse.
If operating system and software is installed, the touch is working and cali-
brated.
Look up for further settings e.g. BIOS on the ETX board manuals.
3.1 CONNECT EXTERNAL DEVICES
To get detailed information about pinout of each connector please look to chapter
"technical details".
COM 3
LAN 1
MOUSE
KEYBOARD
USB
3.1.1 PS/2 Keyboard and Mouse
Use this connector to connect PS/2 mouse and keyboard.
3.1.2 LAN1 Port
This connector provides a external interfaces 10/100 BaseT on RJ45 to connect
your Panel to other devices in a network.
http://www.kontron.com
Attention!
The weight of the Panel is about 7kg
Carry it on with both hands!
Fieldb us
LPT
COM 1
CRT
HDD
POWER
COM 2
LAN 2
RESET
Werner-von-Siemens Str.1
D - 93426 Roding
Tel:
+49 9461 950 - 0
Fax: +49 9461 950 - 100
POWER
Fig. 3-1
9
Advertisement
Table of Contents
