Installation Of Cp6003-Ra Peripheral Devices; Usb Device Installation; Sata Flash Module Installation; Connecting A Peripheral Device To The Cp6003-Ra - Kontron CP6003-RA/RC User Manual

Installation
3.2.4

Installation of CP6003-RA Peripheral Devices

The CP6003-RA is designed to accommodate various peripheral devices, such as USB devic-
es, PMC/XMC modules, rear I/O devices, a SATA Flash module, etc. The following figure
shows the placement of the SATA Flash module on the CP6003-RA.
Figure 3-1:

Connecting a Peripheral Device to the CP6003-RA

The following chapters provide information regarding installation aspects of peripheral devices.
3.2.4.1

USB Device Installation

The CP6003-RA supports all USB Plug and Play computer peripherals (e.g. keyboard, mouse,
printer, etc.).
Note ...
All USB devices may be connected or removed while the host or other
peripherals are powered up.
3.2.4.2

SATA Flash Module Installation

A SATA Flash module may be connected to the CP6003-RA via the onboard connector, J19.
This optionally available module must be physically installed on the CP6003-RA prior to
installation of the CP6003-RA in a system.
During installation it is necessary to ensure that the SATA Flash module is properly seated in
the onboard connector J19, i.e. the pins are aligned correctly and not bent.
Note ...
Only qualified SATA Flash modules from Kontron are authorized for use with
the CP6003-RA. Failure to comply with the above will void the warranty and
may result in damage to the board or the system.
Page 3 - 8
CP6003-RA/RC
SATA Flash
Module
Heat Sink
ID 1046-3890, Rev. 1.0