Standard Board Removal - Kontron CP3005-SA User Manual

4. Fasten the front panel retaining screws.
5. Connect all external interfacing cables to the board as required.

12.2.2. Standard Board Removal

Prior to following the steps below, ensure that the safety requirements are met. When removing a board from the
system, particular attention must be paid to the components which may be hot, such as heat sink, etc.
To remove the CP3005-SA from a system proceed as follows:
1. Ensure that no power is applied to the system before proceeding.
2. Disconnect any interfacing cables that may be connected to the board.
3. Unscrew the front panel retaining screws.
4. Unlock the ejector handle.
5. Disengage the board from the backplane by pressing the handle as required and remove the board from the
system.
www.kontron.com
CP3005-SA – Rev. 0.6 Preliminary
// 76