Sata Interfaces; Rear I/O Interface On Compactpci Connector Rj2; Table 45: Rear I/O Compactpci Connector Rj2 Pinout; Figure 23: Rear I/O Compactpci Connector Rj2 - Kontron CP3005-SA User Manual

Pin Signal
10 GND

10.4.5. SATA Interfaces

The onboard SATA connectors J5 and J6 allow the connection of standard HDDs/SSDs and other SATA devices to the
CP-RIO3-04 rear transition module.

10.4.6. Rear I/O Interface on CompactPCI Connector rJ2

The CP-RIO3-04S rear transition module conducts a wide range of I/O signals through the rear I/O connector rJ2.
To support the rear I/O feature, a 3U CompactPCI backplane with rear I/O support is
required. Do not plug a rear I/O configured board in a backplane without rear I/O support.
Failure to comply with the above will result in damage to your board.

Figure 23: Rear I/O CompactPCI Connector rJ2

Table 45: Rear I/O CompactPCI Connector rJ2 Pinout

Pin Z A
22 NC NC
21 NC NC
20 NC NC
19 NC GND
www.kontron.com
Description
Signal ground
B C
NC NC
GND USBA+/bi
GND USBA-/bi
GND PWR_BTN#/
CP3005-SA – Rev. 0.6 Preliminary
I/O
--
D E
NC NC
USBB+/bi USBA_PWR_
5V/ in
USBB-/bi USBB_PWR_
5V/ in
PWR_SLP RIO_3.3V/in
F
GND
GND
GND
GND
// 71