Table 55: Kontron-Specific Uefi Shell Commands - Kontron CP3005-SA User Manual

13.3.1.3. Kontron-Specific uEFI Shell Commands
The Kontron uEFI implementation provides the following additional commands related to the specific HW features of
the Kontron system.

Table 55: Kontron-Specific uEFI Shell Commands

Command
kboardconfig
kboardinfo
kboot
kbootscript
kflash
www.kontron.com
Description
Configures non-volatile board settings, such as:
 AutoUpdate: Note: If AutoUpdate is enabled, an automatic update procedure from
the connected mass storage device is initiated after a reset. The update status is
indicated in the log file located in the directory where the firmware images are
stored.
 C3State
 C6State
 C7State
 ComA
 cPCISlotClockOut0..7
 CpuTurbo
 cTDP
 GbeA
 GbeB
 IntelHT
 IntelVT
 PrimaryDisplay
 Pxe
 Sata2Hotplug
 Sata3Hotplug
 SataMode
 SataSpeed
 ShellTimeOut
 SpeedStep
 Vga
 WrProtSata
 WrProtSystem
Note: The parameters of the kboardconfig command are not case-sensitive.
Shows a summary of board-specific data and displays/checks various parameters
such as the current uEFI BIOS revision, etc.
Boots a legacy OS Not to be used for uEFI BootLoaders! If the requested device is not
present, boot returns to shell. This command cannot boot native uEFI-aware
operating systems. But since these are bootable from shell by calling their
bootloader, this is not necessary either. If a requested device is present but not
bootable, uEFI continues to boot with the next bootable device in the boot order.
Manages the flash-stored startup script If the shell is launched by the boot process,
it executes a shell script stored in the flash. If the shell script terminates, the shell
will continue the boot process. However, the shell script can also contain any other
boot command.
Programs and verifies the SPI boot flashes holding the uEFI BIOS code, uEFI BIOS
binary files must be available from connected mass storage devices, such as USB
CP3005-SA – Rev. 0.6 Preliminary
// 97