Rear I/O Interface On Compactpci Connector Rj2; Table 40: Rear I/O Compactpci Connector Rj2 Pinout; Figure 20: Rear I/O Compactpci Connector Rj2 - Kontron CP3005-SA User Manual

9.5.7. Rear I/O Interface on CompactPCI Connector rJ2

The CP-RIO3-04 rear transition module conducts a wide range of I/O signals through the rear I/O connector rJ2.
To support the rear I/O feature, a 3U CompactPCI backplane with rear I/O support is
required. Do not plug a rear I/O configured board in a backplane without rear I/O support.
Failure to comply with the above will result in damage to your board.

Figure 20: Rear I/O CompactPCI Connector rJ2

Table 40: Rear I/O CompactPCI Connector rJ2 Pinout

Pin Z A
22 NC NC
21 NC NC
20 NC NC
19 NC GND
18 NC COMA_RXD/out
17 NC COMA_TXD/in
16 NC COMA_DSR#/ou
t
15 NC PWR_5VSTDBY/
out
14 NC IPA_DA+/bi
www.kontron.com
B C
NC NC
GND USBA+/bi
GND USBA-/bi
GND PWR_BTN#/
out
COMA_DCD#/ COMA_DTR#
out /in
COMB_RXD/o NC
ut
COMA_RTS#/i NC
n
RSV NC
IPA_DA-/bi COMB_RTS#
/in
CP3005-SA – Rev. 0.6 Preliminary
D E
NC NC
USBB+/bi USBA_PWR_
5V/ in
USBB-/bi USBB_PWR_
5V/ in
PWR_SLP RIO_3.3V/in
S3#/in
COMB_CT COMA_CTS#
S# /out /out
NC NC
RSV COMA_RI#/o
ut
NC NC
IPA_DC+/ IPA_DC-/bi
bi
F
GND
GND
GND
GND
GND
GND
GND
GND
GND
// 65