Vga Interface; Serial Ports; Gigabit Ethernet; Sata Interfaces - Kontron CP3005-SA User Manual

Table of Contents

Advertisement

Boards with a USB 3.0 flash drive installed on the front panel USB 3.0 port have been found
to slightly exceed the electromagnetic interference limits. If permanent USB 3.0 type
external storage is required to be connected to the USB 3.0 port, it is recommended to use an
external hard disk drive.
On the front panel, the CP3005-SA has two standard, type A, USB 2.0 connectors, J5 and J6.

3.9.3. VGA Interface

The CP3005-SA provides one standard VGA interface for connection to a monitor. The VGA interface is implemented
as a standard HD15 VGA connector, J4, on the front panel.

3.9.4. Serial Ports

The CP3005-SA provides two serial ports:
COMA available either on the CompactPCI rear I/O connector (3.3V LVTTL) or on the MMEXT05 extension module
COMB on the CompactPCI rear I/O connector (3.3V LVTTL)
COMA and COMB are fully compatible with the 16C550 controller and include a complete set of handshaking and
modem control signals. The COMA and COMB ports provide maskable interrupt generation. The data transfer on the
COM ports is up to 115.2 kbit/s.

3.9.5. Gigabit Ethernet

The CP3005-SA board includes two 10/100/1000Base-T Ethernet ports based on one Intel i210-IT controller and one
Intel i219-LM PHY. Both are connected to x1 PCIExpress interfaces of the PCH. These two on-board Gigabit Ethernet
interfaces are individually switchable between front I/O and rear I/O and provide Wake-on-LAN support. In addition,
one 10/100/1000Base-T Ethernet interface based on a intel i210-IT controller is available with the MMEXT05 module.
In order to use the Wake-on-LAN feature available only with the two Ethernet controllers,
the power supply must not be switched off or the +5V stand-by voltage on the rear I/O
module must be available. The CP3005-SA does not turn off the main power supply after an
operating system shutdown in order to support Wake-on-LAN.

3.9.6. SATA Interfaces

The CP3005-SA provides six SATA ports:
One SATA 6 Gb/s port on the onboard standard, 7-pin SATA connector, J3, for connection to SATA devices via
cable
One SATA 6 Gb/s port for the 2.5" HDD/SSD on the MMEXT05 extension module (8HP)
Two SATA 3 Gb/s ports on the CompactPCI rear I/O interface
All six SATA interfaces provide high-performance RAID 0/1/5/10 functionality.
www.kontron.com
CP3005-SA – Rev. 0.6 Preliminary
// 29

Advertisement

Table of Contents
loading

Table of Contents