Default Settings And Configuration - Cisco 350 Series Administration Manual

26
STEP 4
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 1
STEP 2
STEP 3

Default Settings and Configuration

455
Attach the policy to a VLAN, port or LAG using either the
Policy Attachment (Port)
Neighbor Binding Work Flow
In the Neighbor Binding Settings
enabled.
In this same page, set the global configuration values that are used if no values are set in a
policy.
If required, either configure a user-defined policy or add rules the default policies for the
feature.
Add any manual entries required in the Neighbor Binding Table page
Attach the policy to a VLAN, port or LAG using either the
Policy Attachment (Port)
IPv6 Source Guard Work Flow
In the IPv6 Source Guard Settings
enabled.
If required, either configure a user-defined policy or add rules to the default policies for the
feature.
Attach the policy to a VLAN, port or LAG using either the
Policy Attachment (Port)
If IPv6 First Hop Security is enabled on a VLAN, the switch traps the following messages by
default:
• Router Advertisement (RA) messages
pages.
page, enter the list of VLANs on which this feature is
pages.
page, enter the list of VLANs on which this feature is
pages.
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
Security: IPv6 First Hop Security
Default Settings and Configuration
Policy Attachment (VLAN)
Policy Attachment (VLAN)
Policy Attachment (VLAN)
or
or
or