Relationships With Other Features; Common Smartport Tasks - Cisco 350 Series Administration Manual

11

Relationships with Other Features

Common Smartport Tasks

STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
STEP 1
STEP 2
STEP 3
204
Auto Smartport is enabled by default and may be disabled. Telephony OUI cannot function
concurrently with Auto Smartport, and Auto Voice VLAN. Auto Smartport must be disabled
before enabling Telephony OUI.
This section describes some common tasks to setup Smartport and Auto Smartport.
Workflow1: To globally enable Auto Smartport on the device, and to configure a port
with Auto Smartport, perform the following steps:
To enable the Auto Smartport feature on the device, open the
Administrative Auto Smartport to Enable or Enable by Voice VLAN.
Select whether the device is to process CDP and/or LLDP advertisements from connected
devices.
Select which type of devices are to be detected in the Auto Smartport Device Detection field.
Click Apply
To enable the Auto Smartport feature on one or more interfaces, open the
page.
Select the interface, and click Edit.
Select Auto Smartport in the Smartport Application field.
Check or uncheck Persistent Status if desired.
Click Apply.
Workflow2: To configure an interface as a static Smartport, perform the following
steps:
To enable the Smartport feature on the interface, open the
Select the interface, and click Edit.
Select the Smartport type that is to be assigned to the interface in the Smartport Application
field.
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
Relationships with Other Features
Properties page. Set
Interface Settings
Interface Settings page.
Smartport