Cisco 350 Series Administration Manual page 414

IP Configuration
IPv6 Management and Interfaces
STEP 1
STEP 2
STEP 3
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
IPv6 Default Router List
The IPv6 Default Router List page enables configuring and viewing the default IPv6 router
addresses. This list contains the routers that are candidates to become the device default router
for non-local traffic (it may be empty). The device randomly selects a router from the list. The
device supports one static IPv6 default router. Dynamic default routers are routers that have
sent router advertisements to the device IPv6 interface.
When adding or deleting IP addresses, the following events occur:
• When removing an IP interface, all the default router IP addresses are removed.
Dynamic IP addresses cannot be removed.
• An alert message appears after an attempt is made to insert more than a single user-
defined address.
• An alert message appears when attempting to insert a non-link local type address,
meaning 'fe80:'.
To define a default router:
Click IP Configuration > IPv6 Management and Interfaces > IPv6 Default Router List.
This page displays the following fields for each default router:
• Outgoing Interface—Outgoing IPv6 interface where the default router resides.
• Default Router IPv6 Address—Link local IP address of the default router.
• Type—The default router configuration that includes the following options:
- Static—The default router was manually added to this table through the Add button.
- Dynamic—The default router was dynamically configured.
• Metric—Cost of this hop.
Click Add to add a static default router.
Enter the following fields:
• Next Hop Type—The IP address of the next destination to which the packet is sent.
This is composed of the following:
- Global—An IPv6 address that is a global Unicast IPV6 type that is visible and
reachable from other networks.
16
327