Default Settings And Configuration - Cisco SX350 Series Administration Manual

Managed switches

Hide thumbs Also See for SX350 Series:

Table of Contents

Security: IPv6 First Hop Security

Default Settings and Configuration

Default Settings and Configuration

Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x

Attach the policy to a VLAN, port or LAG using either the

Policy Attachment (Port)

Neighbor Binding Work Flow

Neighbor Binding Settings

In this same page, set the global configuration values that are used if no values are set in a

If required, either configure a user-defined policy or add rules the default policies for the

Add any manual entries required in the Neighbor Binding Table page

Attach the policy to a VLAN, port or LAG using either the

Policy Attachment (Port)

IPv6 Source Guard Work Flow

IPv6 Source Guard Settings

If required, either configure a user-defined policy or add rules to the default policies for the

Attach the policy to a VLAN, port or LAG using either the

Policy Attachment (Port)

If IPv6 First Hop Security is enabled on a VLAN, the switch traps the following messages by

Router Advertisement (RA) messages

page, enter the list of VLANs on which this feature is

page, enter the list of VLANs on which this feature is

Policy Attachment (VLAN)

Show Quick Links

Table of Contents