Port Management: Unidirectional Link Detection
Default Settings and Configuration
Default Settings and Configuration
Before You Start
Common UDLD Tasks
STEP 1
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)
•
UDLD and Layer 2 Protocols
UDLD runs on a port independently from other Layer 2 protocols running on
the same port, such as STP or LACP. For example, UDLD assigns the port a
status regardless of the STP status of the port or regardless of whether the
port belongs to a LAG or not.
The following defaults exist for this feature:
•
UDLD is disabled by default on all ports of the device.
•
Default message time is 15 seconds.
•
Default expiration time is 45 seconds (3 times the message time).
•
Default port UDLD state:
-
Fiber interfaces are in the global UDLD state.
-
Non-fiber interfaces are in the disable state.
No preliminary tasks are required.
This section describes some common tasks to setup UDLD.
Workflow1:
To globally enable UDLD on fiber ports, perform the following
steps:
Open the Port Management > UDLD Global Settings page.
a. Enter the Message Time.
b. Select either Disabled, Normal or Aggressive as the global UDLD status.
10
151