Configuration Wizards
Getting Started Wizard
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
This section describes the following configuration wizards:
It covers the following topics:
•
Getting Started Wizard
•
VLAN Configuration Wizard
•
ACL Wizard
This wizard assists in the initial configuration of the device.
Click Configuration Wizards > Getting Started Wizard.
Click Launch Wizard and Next.
Enter the fields:
•
System Location—Enter the physical location of the device.
•
System Contact—Enter the name of a contact person.
•
Host Name—Select the host name of this device. This is used in the prompt of CLI
commands:
-
Use Default—The default hostname (System Name) of these switches is:
switch123456, where 123456 represents the last three bytes of the device MAC
address in hex format.
-
User Defined—Enter the hostname. Use only letters, digits, and hyphens. Host
names cannot begin or end with a hyphen. No other symbols, punctuation
characters, or blank spaces are permitted (as specified in RFC1033, 1034, 1035).
Click Next.
4
40