Configuring Smartport Using The Web-Based Interface - Cisco 350 Series Administration Manual

11
STEP 5
STEP 1
STEP 2
STEP 3
TIP

Configuring Smartport Using The Web-based Interface

STEP 1
STEP 2
206
Return to the main page and reapply the macro using either Reapply (for devices that are not
switches, routers or APs) or Reapply Smartport Macro (for switches, routers or APs) to run
the Smartport Macro on the interface.
A second method of resetting single or multiple unknown interfaces is:
In the Interface Settings
Select Unknown and click Go.
Click Reset All Unknown Smartports. Then reapply the macro as described above.
The reason that the macro failed might be a conflict with a configuration on the interface made
prior to applying the macro (most often encountered with security and storm-control settings),
a wrong port type, a typo or an incorrect command within the user-defined macro, or an invalid
parameter setting. Parameters are checked for neither type nor boundary prior to the attempt to
apply the macro, therefore, an incorrect or invalid input to a parameter value will almost
assuredly cause failure when applying the macro.
The Smartport feature is configured in the Smartport > Properties, Smartport Type Settings
and Interface Settings pages.
For Voice VLAN configuration, see
For LLDP/CDP configuration, see the
respectively.
Properties
To configure the Smartport feature globally:
Click Smartport > Properties.
Enter the parameters.
• Administrative Auto Smartport—Select to globally enable or disable Auto
Smartport. The following options are available:
- Disable—Select to disable Auto Smartport on the device.
Configuring Smartport Using The Web-based Interface
page, select the Port Type equals to checkbox.
Voice VLAN.
Discover - LLDP
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
and Discovery - CDP sections,
Smartport