Cisco 350 Series Administration Manual page 675

SNMP
Engine ID
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
To define the SNMP engine ID:
Click SNMP > Engine ID.
Choose which to use for Local Engine ID.
• Use Default—Select to use the device-generated engine ID. The default engine ID is
based on the device MAC address, and is defined per standard as:
- First 4 octets—First bit = 1, the rest is the IANA enterprise number.
- Fifth octet—Set to 3 to indicate the MAC address that follows.
- Last 6 octets—MAC address of the device.
• None—No engine ID is used.
• User Defined—Enter the local device engine ID. The field value is a hexadecimal
string (range: 10 - 64). Each byte in the hexadecimal character strings is represented by
two hexadecimal digits.
All remote engine IDs and their IP addresses are displayed in the Remote Engine ID table.
Click Apply. The Running Configuration file is updated.
The Remote Engine ID table shows the mapping between IP addresses of the engine and
Engine ID.
To add the IP address of an engine ID:
Click Add. Enter the following fields:
• Server Definition—Select whether to specify the Engine ID server by IP address or
name.
• IP Version—Select the supported IP format.
• IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The options are:
- Link Local—The IPv6 address uniquely identifies hosts on a single network link. A
link local address has a prefix of FE80, is not routable, and can be used for
communication on the local network only. Only one link local address is supported.
If a link local address exists on the interface, this entry replaces the address in the
configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface—Select the link local interface (if IPv6 Address Type Link Local
is selected) from the list.
24
453