Cisco 350 Series Administration Manual page 758

25
532
-
PoE power and data inactive
Editable Parameters
•
PoE Administrative Status (Enabled/Disabled)—This control only appears if at least
one PoE ports is selected for the service, and is only applied to the PoE ports.
•
Port Power Priority (Low/High/Critical)—This control only appears if at least one PoE
ports is selected for the service, and is only applied to the PoE ports.
•
SNA Power Schedule (Applied/Not Applied—This control appears only if the device
has a power schedule created by SNA.
•
Schedule behavior—This control appears only if the user chooses to apply the
schedule. Possible values include:
-
PoE power inactive
-
Data inactive
-
PoE power and data inactive
If no PoE ports are selected, the schedule can only be applied or removed from the port, and no
behavior can be selected. Applying the schedule to the ports has the same behavior as selecting
the Data inactive option.
If a combination of PoE and non-PoE ports is selected, when applying the settings to the PoE
ports, the option PoE power and data inactive is treated as if it were Data inactive, and
the option PoE power inactive is treated as if the schedule was not activated on the non-
PoE port.
VLAN Membership (Interface Level)
This service configures the VLAN membership of the selected interfaces.
Displayed/Editable Parameters
•
Interface Name (Read-Only)
•
Switchport Mode—For display, can be Access, Trunk, General, Customer, Private -
Host, Private - Promiscious. When configuring, the user can choose Access or Trunk.
•
Access VLAN—Appears only in Access mode. When displayed shows the Access
VLAN ID, and when configuring allows selection of the access VLAN.
•
Native VLAN (SNA version 2.3)—Appears only in Trunk mode. When displayed it
shows the Native VLAN ID, and when configuring allows selection of the native
VLAN.
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
Smart Network Application (SNA)
Services