Cisco 350 Series Administration Manual page 437

18
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
341
To enable/disable RIP on the device.
Click IP Configuration > IPv4 Management and Interfaces> RIPv2 > RIPv2 Properties.
Select the following options as required:
• RIP—The following options are available:
- Enable—Enable RIP.
- Disable—Disable RIP. Disabling RIP deletes the RIP configuration on the system.
- Shutdown—Set the RIP global state to shutdown.
• RIP Advertisement—Select to enable sending routing updates on all RIP IP interfaces.
• Default Route Advertisement—Select to enable sending the default route to the RIP
domain. This route will serve as the default router.
• Default Metric—Enter the value of the default metric (refer to
Redistribute Static Route—Select to enable this feature (described in
If Redistribute Static Route is enabled, select an option for the Redistribute Static Metric
field. The following options are available:
• Default Metric—Causes RIP to use the default metric value for the propagated static
route configuration (refer to
• Transparent—Causes RIP to use the routing table metric as the RIP metric for the
propagated static route configuration. This results in the following behavior:
- If the metric value of a static route is equal to or less than 15, this value is used in
the RIP protocol when advertising this static route.
- If the metric value of a static route is greater than 15, the static route is not advertised
to other routers using RIP.
• User Defined Metric—Enter the value of the metric.
Redistribute Connected Route—Select to enable this feature (described in Redistributing
Static Route Configuration.
If Redistribute Connected Route is enabled, select an option for the Redistribute
Connected Metric field. The following options are available:
• Default Metric—Causes RIP to use the default metric value for the propagated static
route configuration (refer to
Redistribution
Redistribution
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
IP Configuration: RIPv2
Redistribution
Redistribution
Feature).
Feature).
Configuring RIP
Feature).
Feature.