Acl Wizard - Cisco 350 Series Administration Manual

Configuration Wizards

ACL Wizard

STEP 9
STEP 10
ACL Wizard
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
Click Next to see the summary of the information that you entered.
Click Apply.
To create a new ACL.
Click Configuration Wizards > ACL Wizard.
Click Next.
Enter the fields:
• ACL Name—Enter the name of a new ACL.
• ACL Type—Select the type of ACL: IPv4 or MAC.
Click Next.
Enter the fields:
• Action on match—Select one of the options:
- Permit Traffic—Forward packets that meet the ACL criteria.
- Deny Traffic—Drop packets that meet the ACL criteria.
- Shutdown Interface—Drop packets that meet the ACL criteria, and disable the port
from where the packets received. Such ports can be reactivated from the
Recovery Settings
For a MAC-based ACL, enter the fields:
• Source MAC Address—Select Any if all source address are acceptable or User defined
to enter a source address or range of source addresses.
• Source MAC Value—Enter the MAC address to which the source MAC address is to
be matched and its mask (if relevant).
• Source MAC Wildcard Mask—Enter the mask to define a range of MAC addresses.
• Destination MAC Address—Select Any if all destination addresses are acceptable or
User defined to enter a destination address or a range of destination addresses.
• Destination MAC Value—Enter the MAC address to which the destination MAC
address is to be matched and its mask (if relevant).
page.
4
Error
43