Cisco 350 Series Administration Manual page 109

6
STEP 3
86
• Link Local Interface—If the source IPv6 address type is Link Local, select from where
it is received.
• Server IP Address/Name—Enter the IP address or domain name of the PNP server.
PNP User
• User Definition—User information to be sent in PNP packets sent to the server. Select
one of the following options:
- Default Value—When selecting this option, the PNP username and password
settings are taken from DHCP option 43. If this option is selected the username and
password fields are grayed out.
- Manual Settings—Select to manually configure PNP username and password.
• Username—Username to be entered in the PNP packets.
• Password—Password in either Encrypted or Plaintext form.
PNP Behavior Settings—Enter the following parameters:
• Reconnection Interval—Interval in seconds before attempting to reconnect the session
after the connection is lost.
• Discovery Timeout—Specifies the time to wait, in seconds, before attempting
discovery again after a discovery of the PNP server failed.
• Timeout Exponential Factor—Value that triggers the discovery attempt exponentially.
by multiplying the previous timeout value by an exponential value and applying the
result as timeout (if value is smaller than max timeout value).
• Max Discovery Timeout—.Maximum value of timeout. Must be greater than the
Discovery Timeout value.
• Watchdog Timeout—Interval of time to wait for a reply from a PnP or file server
during an active PNP session (for example during a file download process).
Click Apply. The parameters are copied to the Running Configuration file.
Click Display Sensitive Data as Plaintext to display the password if it is encrypted.
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
Administration
Plug-n-Play (PNP)