Cisco 350 Series Administration Manual page 95

5
STEP 5
STEP 6
STEP 1
STEP 2
STEP 3
82
• Link Local Interface—Select the link local interface (if IPv6 is used) from the list.
Enter the fields:
• Receiver IP Address/Name—Enter the IP address or the name of the receiver,
whichever is relevant.
• Port—Port to which SYSLOG message are sent.
• Maximum Datagram Size—Maximum number of bytes that can be sent to the receiver
in a single sample datagram (frame).
Click Apply.
sFlow Interface Settings
To sample datagrams or counters from a port, the port must be associated with a receiver.
sFlow port settings can be configured only after a receiver has been defined in the
Receiver Settings pages.
To enable sampling and configure the port from which to collect the sFlow information:
Click Status and Statistics > sFlow > sFlow Interface Settings.
The sFlow interface settings are displayed.
To associate an sFlow receiver with a port, select a port, click Edit, and enter the fields:
- Interface—Select the unit/port from which information is collected.
- (Flow Sampling) State—Enable/disable flow sampling.
- Sampling Rate—If x is entered, a flow sample will be taken for each x frames.
- Maximum Header Size—Maximum number of bytes that should be copied from a
sampled packet.
- Receiver Index—Select one of the indices that was defined in the
Settings pages.
- (Counter Sampling) State—Enable/disable counters sampling.
- Sampling Interval—If x is entered, this specifies that a counter sample will be
taken for each x seconds.
- Receiver Index—Select one of the indices that was defined in these
Receiver Settings
Click Apply.
pages.
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
Status and Statistics
sFlow
sFlow
sFlow Receiver
sFlow