Cisco 350 Series Administration Manual page 102

Administration
User Accounts
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
For information on password recover, see
To add a new user:
Click Administration > User Accounts.
This page displays the users defined in the system and their user privilege level.
Click Add to add a new user or click Edit to modify a user.
Enter the parameters.
• User Name—Enter a new username between 0 and 20 characters. UTF-8 characters are
not permitted.
• Password—Enter a password (UTF-8 characters are not permitted). If the password
strength and complexity is defined, the user password must comply with the policy
configured in Password
• Confirm Password—Enter the password again.
• Password Strength Meter—Displays the strength of password. The policy for
password strength and complexity are configured in the
• User Level—Select the privilege level of the user being added/edited.
- Read-Only CLI Access (1)—User cannot access the GUI, and can only access CLI
commands that do not change the device configuration.
- Read/Limited Write CLI Access (7)—User cannot access the GUI, and can only
access some CLI commands that change the device configuration. See the CLI
Reference Guide for more information.
- Read/Write Management Access (15)—User can access the GUI, and can configure
the device.
Click Apply. The user is added to the Running Configuration file of the device.
Menu CLI and Password
Strength.
6
Recovery.
Password Strength page.
79