Cisco 350 Series Administration Manual page 362

15
STEP 4
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
280
MLD Proxy
To configure MLD Proxy:
Click Multicast > IPv6 Multicast Configuration > MLD Proxy.
Enter the following fields:
• MLD Multicast Routing—Select to enable IPv6 Multicast routing.
• Downstream Protection—Select to discard downstream packets not required for the
device.
• Source Specific Multicast—Select to enable delivering Multicast packets originating
from a specific source address defined in the next field.
• SSM IPv6 Access List—Define the list containing source addresses from which to
deliver Multicast packets:
- Default list—Defines the SSM range access list to FF3E::/32.
- User defined access list—Select the standard IPv6 access list name defining the
SSM range. These access lists are defined in
Click Apply. The Running Configuration file is updated.
To add protection to a VLAN, click Add and enter the following fields:
• Upstream Interface—Select the outgoing interface.
• Downstream Interface—Select the incoming interface.
• Downstream Protection—Select one of the following options:
- Use Global—Use the status set in the global block.
- Disable—This enables forwarding of IPv6 Multicast traffic from downstream
interfaces.
- Enable—This disables forwarding from downstream interfaces.
Click Apply. The Running Configuration file is updated.
The following fields are displayed for each IP Multicast route:
• Source Address—Unicast source IPv4 address.
• Group Address—Multicast destination IPv4 address.
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
IPv6 Multicast Configuration
Access Lists.
Multicast