Link Aggregation - Cisco 350 Series Administration Manual

10
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8

Link Aggregation

168
Configuring LBD
To enable and configure LBD:
Enable Loopback Detection system-wide in the Loopback Detection Settings page (below).
Enable Loopback Detection on access ports in the Loopback Detection Settings page (below).
Enable Auto-Recovery for Loopback Detection in the
To configure Loopback Detection:
Click Port Management > Loopback Detection Settings.
Select Enable in the Loopback Detection global field to enable the feature.
Enter the Detection Interval. This is the interval between transmission of LBD packets.
Click Apply to save the configuration to the Running Configuration file.
The following fields are displayed for each interface, regarding the Loopback Detection
State:
• Administrative—Loopback detection is enabled.
• Operational—Loopback detection is enabled but not active on the interface.
Select whether to enable LBD on ports or LAGS in the Interface Type equals field in the
filter.
Select the ports or LAGs on which LBD is to be enabled and click Edit.
Select Enable in the Loopback Detection State field for the port or LAG selected.
Click Apply to save the configuration to the Running Configuration file.
This section describes how to configure LAGs. It covers the following topics:
• Link Aggregation Overview
• Default Settings and Configuration
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
Port Management
Error Recovery Settings
Link Aggregation
page.