Qos And Cos Features; Monitoring Features; Default Settings After Initial Switch Configuration - Cisco Catalyst 2360 Software Configuration Manual

Default Settings After Initial Switch Configuration

•
•

QoS and CoS Features

•
•

Monitoring Features

•
•
•
•
•
•
•
Default Settings After Initial Switch Configuration
You only need to assign basic IP information to the switch and connect it to other network devices.
Note To assign an IP address by using the browser-based Express Setup program, see the getting started guide.
To assign an IP address by using the CLI-based setup program, see the hardware installation guide.
If you do not configure the switch, the switch operates with these default settings:
•
•
Catalyst 2360 Switch Software Configuration Guide
1-6
Kerberos security system to authenticate requests for network resources by using a trusted third
party (requires the cryptographic software image)
Secure Socket Layer (SSL) Version 3.0 support for the HTTP 1.1 server authentication, encryption,
and message integrity and HTTP client authentication to allow secure HTTP communications
(requires the cryptographic software image)
Classification
802.1p class of service marking priorities on a per-port basis to protect the performance of
–
mission-critical applications
Egress queues and scheduling
Four egress queues per port
–
Switch LEDs provide port and switch status
MAC address notification traps and RADIUS accounting to track users on a network, storing the
MAC addresses that the switch has learned or removed
Switched Port Analyzer (SPAN) to traffic monitor on any port or VLAN
SPAN support of Intrusion Detection Systems (IDS) to monitor, repel, and report network security
violations
Four groups (history, statistics, alarms, and events) of embedded RMON agents for network
monitoring and traffic analysis
Syslog facility for logging system messages about authentication or authorization errors, resource
issues, and time-out events
Online diagnostics to test the hardware functionality of the supervisor engine, modules, and switch
while the switch is connected to a network
Default switch IP address, subnet mask, and default gateway is 0.0.0.0. For information, see
Chapter 3, "Assigning the Switch IP Address and Default Gateway,"
DHCP Features."
Default domain name is not configured. For information, see
Address and Default Gateway."
Chapter 1
and Chapter 14, "Configuring
Chapter 3, "Assigning the Switch IP
OL-19808-01
Overview