Configuring Rip - Cisco 350 Series Administration Manual

IP Configuration: RIPv2

Configuring RIP

Configuring RIP
NOTE
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
The following actions can be performed.
• Mandatory actions:
- Globally enable/disable RIP protocol, using the
- Enable/disable RIP protocol on an IP interface, using the
• Optional actions (if these are not performed, default values are used by the system)
- Enable/disable RIP to advertise static or connected routes and its metric on the IP
interface, using the
- Configure the offset added to the metric for incoming routes on an IP interface,
using theRIPv2 Settings
- Enable passive mode on an IP interface, using the
- Control which routes are processed in the incoming/outgoing routing updates by
specifying an IP address list on the IP interface (see
- Advertise default route entries on the IP interface, using the
- Enable RIP authentication on an IP Interface, using the
The following pages are described:
• RIPv2 Properties
• RIPv2 Settings
• RIPv2 Statistic
• RIPv2 Peers Database
RIPv2 Properties
This feature is only supported on 550 family of devices.
RIPv2 Properties page.
page.
RIPv2 Properties page.
RIPv2 Settings
RIPv2 Settings page.
Access Lists).
RIPv2 Settings
RIPv2 Settings page.
18
page.
page.
340