Cisco 350 Series Administration Manual page 757

Smart Network Application (SNA)
Services
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
Interface-Level Services
Some services are relevant to interfaces rather than devices. When activating these services,
select one or more interfaces and then select a service from the list of services available.
The following services are available for interfaces:
• Power Management Settings (Port)—PoE priority and applying schedule
Power Management Settings (Interface Level)
behavior. See
• VLAN Membership (port/LAG) — Switchport type (Access and Trunk),
membership for Access and Trunk. See
For each of these services, the tickets showing the current configurations for the selected
interfaces display the following identifying information in addition to service specific
parameters:
•
Interface name
•
Device host name (of the parent device of the interface)
•
IP address (of the parent device of the interface)—If more than one IP address exists
for the device, the IP address used by SNA to access the device is displayed.
•
Device model (of the parent device of the interface)—The alphanumeric string
representing the device model. For example: SG350XG-2F10.
Power Management Settings (Interface Level)
This service configures the Power settings on specific ports. This service can only be run when
all selected ports belong to the same device (or stack).
Displayed Parameters
•
PoE Administrative Status (Enabled/Disabled)—This parameter only appears for PoE
ports.
•
Port Power Priority (Low/High/Critical)—This parameter only appears for PoE ports.
•
SNA Power Schedule (Applied/Not Applied)—This parameter appears only if the
device has a power schedule created by SNA.
•
Schedule behavior—This information appears only if the port has an applied SNA-
defined power schedule. The possible values are:
-
PoE power inactive
-
Data inactive
VLAN Membership (Interface Level)
25
531