Cisco 350 Series Administration Manual page 130

7
STEP 3
STEP 1
STEP 2
STEP 3
104
Click Apply to begin the operation.
To backup a system configuration file using SCP:
Click Administration > File Management > File Operations.
Enter the following fields:
• Operation Type—Select Backup File.
• Source File Type—Select the type of file to be backed up.
• Copy Method—Select SCP.
• Remote SSH Server Authentication—The current state of the remote SSH server
authentication. Click Edit to go to SSH Server Authentication and change the setting.
See SSH User Authentication
• Remote SSH Server Authentication—To enable SSH server authentication (it is
disabled by default), click Edit, which takes you to the
to configure this, and return to this page. Use the
select an SSH user authentication method (password or public/private key), set a
username and password on the device, if the password method is selected, and generate
an RSA or DSA key if required.
SSH Client Authentication—Client authentication can be done in one of the following ways:
• Use SSH Client System Credentials—Sets permanent SSH user credentials. Click
System Credentials to go to the SSH User Authentication page where the user/
password can be set once for all future use.
• Use SSH Client One-Time Credentials—Enter the following:
- Username—Enter a username for this copy action.
- Password—Enter a password for this copy.
• Server Definition—Select whether to specify the SCP server by IP address or by
domain name.
• IP Version—Select whether an IPv4 or an IPv6 address is used.
for instructions. Then enter the following fields:
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
Administration: File Management
File Operations
SSH Server Authentication
SSH Server Authentication
page
page to