Port Utilization; Gvrp - Cisco 350 Series Administration Manual

5
STEP 3

Port Utilization

STEP 1
STEP 2

GVRP

52
• Pause Frames Transmitted—Flow control pause frames transmitted from the selected
interface.
To view statistics counters in table view, click View All Interfaces Statistics to see all ports in
table view.
The Port Utilization page displays utilization of broadband (both incoming and outgoing) per
port.
To display port utilization:
Click Status and Statistics > Port Utilization.
Enter the Refresh Rate, which is the time period that passes before the interface Ethernet
statistics are refreshed.
The following fields are displayed for each port:
• Interface—Name of port.
• Tx Utilization—Amount of bandwidth used by outgoing packets.
• Rx Utilization—Amount of bandwidth used by incoming packets.
To view a graph of historical utilization over time on the port, select a port and click View
Interface History Graph. In addition to the above, the following field is displayed:
• Time Span—Select a unit of time. The graph displays the port utilization over this unit
of time.
The GVRP page displays information regarding GARP VLAN Registration Protocol (GVRP)
frames that sent or received from a port. GVRP is a standards-based Layer 2 network protocol,
for automatic configuration of VLAN information on switches. It is defined in the 802.1ak
amendment to 802.1Q-2005.
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
Status and Statistics
Port Utilization