Cisco 350 Series Administration Manual page 204

Administration: Discovery
Discovery - CDP
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
To view the CDP neighbors information:
Click Administration > Discovery - CDP > CDP Neighbor Information.
To select a filter, check the Filter checkbox, select a Local interface, and click Go.
The filter is triggered, and Clear Filter is activated.
Click Clear Filter to stop the filter.
The CDP Neighbor Information page contains the following fields for the link partner
(neighbor):
• Device ID—Neighbors device ID.
• System Name—Neighbors system name.
• Local Interface—Number of the local port to which the neighbor is connected.
• Advertisement Version—CDP protocol version.
• Time to Live (sec)—Time interval (in seconds) after which the information for this
neighbor is deleted.
• Capabilities—Capabilities advertised by neighbor.
• Platform—Information from Platform TLV of neighbor.
• Neighbor Interface—Outgoing interface of the neighbor.
Select a device, and click Details.
This page contains the following fields about the neighbor:
• Device ID—Identifier of the neighboring device ID.
• System Name—Name of the neighboring device ID.
• Local Interface—Interface number of port through which frame arrived.
• Advertisement Version—Version of CDP.
• Time to Live—Time interval (in seconds) after which the information for this neighbor
is deleted.
• Capabilities—Primary functions of the device. The capabilities are indicated by two
octets. Bits 0 through 7 indicate Other, Repeater, Bridge, WLAN AP, Router,
Telephone, DOCSIS cable device, and station respectively. Bits 8 through 15 are
reserved.
• Platform—Identifier of the neighbors platform.
9
157