Warning
Do not strip more than the recommended amount of wire. Stripping
more than the recommended amount can create a safety hazard by
leaving exposed wire on the terminal block after installation. E10
5. Insert the power supply ground wire into the middle connector of the
DC terminal and tighten the connection with a flathead screwdriver, as
shown in Figure 56.
Warning
When installing this equipment, always ensure that the power supply
ground connection is installed first and disconnected last. E11
Figure 56. Connecting the Ground Wire to the DC Terminal Block
x930 Series Installation Guide for Stand-alone Switches
8mm +/- 1mm
(0.31 in. +/- 0.039 in.)
Figure 55. Stripped Wire
113