Warning
Do not strip more than the recommended amount of wire. Stripping
more than the recommended amount can create a safety hazard by
leaving exposed wire on the terminal block after installation. E10
5. Insert the power supply ground wire into the middle connector of the
DC terminal and tighten the connection with a flathead screwdriver.
Refer to Figure 69.
Warning
When installing this equipment, always ensure that the power supply
ground connection is installed first and disconnected last. E11
Figure 69. Connecting the Ground Wire to the DC Terminal Block
x930 Series Installation Guide for Virtual Chassis Stacking
8mm +/- 1mm
(0.31 in. +/- 0.039 in.)
Figure 68. Stripped Wire
139