Bt Cradle Setup Barcodes & Serial Commands - CipherLab 2560 User Manual

For the scanner to read the serial number and beep –

#@RDSN<CR>
#@////<CR>
Note: (1) For RS-232 or USB Virtual COM, you can only configure the first scanner that
connects to cradle. To identify the scanner, you may send the serial command to
have it respond with a beep.
(2) For BT SPP, you can configure up to seven scanners at the same time.
BT CRADLE SETUP BARCODES & SERIAL COMMANDS
Normally, you can configure the BT cradle by having a connected scanner read
cradle-related setup barcodes.
1) Connect the interface cable, RS-232, Keyboard Wedge or USB, between the cradle
and your computer.
For USB Virtual COM, you may need to install its driver first!
2) Connect the power supply cord from cradle to a proper power outlet.
3) Refer to 3.1.1 Connect to Cradle
Read the MAC address label located at the back of the cradle.
4) Read the following barcodes in sequence to configure the cradle.
For cradle-related setup barcodes, refer to the Serial Command table below. Note that
for the "Version" and "GetID" barcodes, you must run HyperTerminal.exe or any text
editor to receive the information.
If the output interface is RS-232 or USB Virtual COM, run HyperTerminal.exe on

your computer to receive the information.
If the output interface is Keyboard Wedge or USB HID, run any text editor to

receive the information.
for the target scanner to connect to cradle.
Enter Setup
(Cradle-related setup barcodes)
Update
Appendix II Host Serial Commands
Update
219