Enter Configuration Mode; Exit Configuration Mode - CipherLab 1660 User Manual

1660 Barcode Scanner
* When any configuration error occurs...

ENTER CONFIGURATION MODE

For the scanner to enter the configuration mode, you must have it read the "Enter Setup"
label, which can be located at the bottom of almost every even page of this manual.
The scanner will respond with six beeps and its LED indicator will become flashing red
after reading the label.
For configuring scanner parameters, see "Read a Setup Label" below.

EXIT CONFIGURATION MODE

For the scanner to exit the configuration mode, you must have it read the "Update" label,
which can be located at the bottom of almost every odd page of this manual. If you want
to exit the configuration mode without saving any changes, have the scanner read the
"Abort" label instead.
Just like reading the "Enter Setup" label, the scanner will respond with six beeps and
its LED indicator will become flashing red after reading the label. Wait for a few
seconds for the scanner to restart itself.
Update
4
User Guide
Enter Setup
The scanner will respond with one long
beep (low tone).
Abort