Figure 107: Returning To The Privileged Exec Mode; Figure 108: Saving The Priority Values With The Write Command - Allied Telesis AT-SB*908 GEN2 Installation Manual

Chapter 8: Powering On and Verifying the Stack
176
3. After setting the priority values, enter the EXIT command to return to
the Privileged Exec mode, as shown in Figure 107.
awplus(config)# exit
awplus#
Figure 107. Returning to the Privileged Exec Mode
4. Enter the WRITE command to save your change in the configuration
file. The switch displays the confirmation prompt in Figure 108.
awplus# write
Building configuration ...
[OK]
awplus#
Figure 108. Saving the Priority Values with the WRITE Command
5. To end the management session, enter the EXIT command.
The installation is complete. For further instructions, refer to the
Software Reference for SwitchBlade x908 GEN2 Series Switches.