Table of Contents
Advertisement
Installing Blank Line Card Slot Covers
After installing the Ethernet line cards, inspect slots 1 to 8 for empty slots.
Empty slots need to be covered with the blank slot covers that come with
the chassis. Do one of the following:
If there are no empty, uncovered line card slots, go to "Installing
the Blank Power Supply Slot Cover" on page 101.
If there are empty, uncovered line card slots, perform the following
procedure.
To install blank slot covers, perform the following procedure:
1. Position the blank slot cover with the notch in the upper left and slide it
into the empty slot. Refer to Figure 54.
Notch
Figure 54. Installing a Blank Slot Cover
2. Tighten the two captive screws with a #2 Phillips-head screwdriver to
secure the cover to the chassis. Refer to Figure 55 on page 100.
AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
99
Advertisement
Table of Contents
