Table of Contents
Advertisement
Console (RS-232)
Port
Switch ID LED
The Network Management (NET MGMT) port has one Status LED,
described in Table 7.
Table 7. NET MGMT Port LED
State
Solid Green
Flashing Green
Solid Amber
Flashing Amber
Off
You can use the Console Port to conduct local management sessions of
the switch. Local management sessions require a terminal or PC with a
terminal emulation program, and the management cable that comes with
the switch.
Local management sessions are not conducted over a network.
Consequently, the switch does not need an Internet Protocol (IP) address
for this type of management.
Because the switch does not come with a default IP address, your initial
management session must be a local management session. For
instructions on how to start a local management session, refer to "Starting
a Local Management Session" on page 145 or the Software Reference for
SwitchBlade x908 Gen2 Switch.
The Switch ID LED, shown in Figure 4 on page 27, displays the ID number
of the switch. The states of the LED when the switch is not operating in the
low power mode are shown in Figure 5 on page 30.
AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
Description
The port has established a 1000 Mbps link
with a network device.
The port is transmitting or receiving data
at 1000 Mbps.
The port has established a 10 or 100
Mbps link.
The port is transmitting or receiving data
at 10 or 100 Mbps.
The port has not established a link to a
network device.
29
Advertisement
Table of Contents
