Table of Contents
Advertisement
Table 14. Example of Designating Trunk Ports (Continued)
awplus> enable
awplus#
awplus# show stack detail
.
.
.
Stack port1.2.1 status
Stack port1.5.4 status
Command
AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
Start a new management
session on the switch. For
instructions, refer to "Starting a
Local Management Session" on
page 145.
Enter the ENABLE command to
move from the User Exec mode
to the Privileged Exec mode.
Enter the SHOW STACK
DETAIL command to confirm
that the designated ports are
now trunk ports. (The status of
the ports should be Down at this
point because the ports are not
Down
cabled yet.)
Down
Go to "Powering Off the Switch"
on page 156.
Description
155
Advertisement
Table of Contents
