Editing A Channel; Configuring The Lens - Christie Mirage M Series User Manual

Editing a channel

1. To display the Main menu, press Menu from the presentation level.
2. To display the Channel Setup menu, press 3 or move the highlight to the Channel Setup option
and press Enter.
3. To edit parameters shown in the Channel Setup menu, select the relevant channel and press
Enter.
4. If required, review and/or edit the following channel setups in the Channel Edit menu:
Field Description
Name An alphanumeric label can be defined and/or changed here. Channel names can be up
to 12 characters in length. The default name is the horizontal and vertical sync
frequencies.
Channel A two-digit channel number can be changed here. If you enter a channel number that
already exists, a dialog message appears indicating that this number is already in use;
assign a different channel number. You can define up to 99 channels.
Slot 1-4, corresponding to which slot in the projector's input panel the source is connected.
Input 1-6, corresponding to which input on the selected slot the source is connected to.
In Menu If checked (default, except for automatically defined channels with unchanged
parameters), this defined channel appears in the list available when Channel key is
pressed. If unchecked, the channel must be accessed through Channel on the keypad
or through the Auto Source function. On-screen display of the channel list is an option
that must be set in the Menu Preferences menu.
Auto Select If checked, (default), the projector can automatically locate this channel when an
incoming input signal matches. If not checked, the projector can locate the selected
channel only when it is directly selected with Channel on the keypad; a change in input
signal does not result in a channel change.
Locked If checked, all of the image settings for this channel are locked. If unchecked (default),
all available image settings can be adjusted as required. You cannot use Auto Setup with
a locked channel.
Previous Channel Select this option to see or change Channel Edit settings for the previous channel in the
Channel Setup list.
Next Channel Select this option to see or change Channel Edit settings for the next channel in the
Channel Setup list.

Configuring the lens

1. In Configuration > Lens Settings, configure the following:
• Intelligent Lens System—Enables the Intelligent Lens System (ILS). When
enabled, the lens position (horizontal, vertical, focus, and zoom offsets) are stored per
channel. If you change channels, the lens position changes as the new signal is being
displayed. When ILS is not enabled, the lens is controlled independently of channels or
input signals.
Mirage M Series User Manual
020-101942-02 Rev. 1 (10-2018)
http://www.pureglare.com.au
Operating the projector
67