Adding A Scheduled Event - Christie Mirage M Series User Manual
High resolution video/graphics three chip 1080p hd, sxga+, and wuxga projectors.
Hide thumbs
Also See for Mirage M Series:
- User manual (162 pages) ,
- Setup manual (72 pages) ,
- Instruction sheet (3 pages)
Table of Contents
Advertisement
Message:
Projector Name: <projector name>
Location: <SNMP location>
IP Address: <IP address>
Description: <message>
Parameters: <param 1> = <param 1 value>; <param 2 > = <param 2 value>; ...
Adding a scheduled event
1. Click Advanced > RTE.
2. To open the RTE Wizard click Add.
3. Select the Scheduled Event tab.
The scheduled tab is always selected by default on add.
4. Select the frequency option for the event by selecting either Once, Daily, Weekly, or
Monthly. End Date is enabled when Daily, Weekly or Monthly repeat options are selected.
5. Click within the Start Time field to open a calendar pop-up window.
6. Navigate to and choose a required date.
The selected date populates the Start Time field.
7. In the field below the Start Time field, enter a start time in the format "hr:min:sec".
The default is the current time.
8. To set the computer and projector time to be the same, click Sync; otherwise, the event runs
based on the projector time.
9. Enter a description of the scheduled event, with a maximum of 100 characters.
10. Enter a serial command or a sequence of serial commands for the projector to perform in the
Command String field.
•
If a GPIO command string is needed, click GPIO Output Helper for instructions on
how to create the command structure.
The Output field contains seven blocks which refer to the seven I/O pins on the GPIO
connector. Pin 1 = +12V and Pin 5 = Ground. These are not included. Clicking a block
toggles between H, L, and X. If the Pulse check box is selected, those I/O Pins defined
pulse high or low. See
information. The Serial Representation box is read only.
•
For a description of special RTE commands available for adding loops and delays to the
command sequence click Help.
•
To test the entered command string, click Test.
If the test passed or failed, a green or red icon appears to the right side of the Test
button.
11. Click Finish.
Mirage M Series User Manual
020-101942-02 Rev. 1 (10-2018)
http://www.pureglare.com.au
Connecting to the GPIO connector
Monitoring and Maintenance
on page 42 for detailed
110
Advertisement
Table of Contents
