Connecting Multiple Projectors - Christie Mirage M Series User Manual

RS422 pins
Pin # Signal
Pin 1 DNC
Pin 2 RXD-
Pin 3 TXD-
Pin 4 RXD+
Pin 5 TXD+
Pin 6 DNC
Pin 7 GND
Pin 8 NC
Pin 9 +12V(500mA)
* DNC are do-not-connect pins.
* NC are no-connect pins.

Connecting multiple projectors

Notice. Failure to comply with the following may result in property damage.
• Connect only high quality, properly wired serial communication cables.
• Each RS232 communication cable should be no more than 50 feet in length.
RS232 network
To connect multiple projectors in a network with serial communication, complete the following
steps:
1. Connect the controller source to the RS232 IN connector of the first projector in the network.
2. Use another serial communication cable to connect one end to the RS232 OUT connector and
the other end to the RS232 IN connector of the next projector.
Mirage M Series User Manual
020-101942-02 Rev. 1 (10-2018)
http://www.pureglare.com.au
Direction
N/A
IN
OUT
IN
OUT
N/A
N/A
N/A
OUT
Installation and Setup
39