Positioning The Projector - Christie Mirage M Series User Manual

4. While holding the lens flat against the lens mount, rotate the lens clamp clockwise to lock the
lens assembly in place.
5. Remove the front lens cap.
6. For added stability such as motion application, fasten the security screws provide with the lens-
mount.
7. Use a 5mm hex driver to fasten the red security screws provided with the lens mount, or hand
tighten the lens retaining screws attached to the lens. Christie recommends this for heaviest
lenses such as 0.73:1 and 1.2:1.
8. If the projector is hoisted or installed in an overhead position use the lens red security screws
or the lens retaining screws.

Positioning the projector

Warning! Failure to comply with the following could result in death or serious injury.
• Two people are required to safely lift and install the projector.
Place the projector on a sturdy, level surface and position it so that it is perpendicular to the screen
at a suitable distance. The further back the projector is positioned for the screen, the larger the
image becomes.
To level the projector adjust its three feet. With the projector positioned perpendicular to the screen
the image appears rectangular instead of keystoned.
Mirage M Series User Manual
020-101942-02 Rev. 1 (10-2018)
http://www.pureglare.com.au
Installation and Setup
22