Connecting The Line Cord; Powering On The Projector - Christie Mirage M Series User Manual

Option card
Dual Link DVI input card
Twin DHDMI input card
Video Decoder input card
DMX512 interface card
TwinDisplay input card
See Connecting sources through option cards

Connecting the line cord

Warning! Failure to comply with the following could result in death or serious injury.
• Do not attempt operation if the AC supply and cord is not within the specified ratings. Use the line
cord provided with the projector, or ensure you are using a line cord, power plug, and socket that
meet the appropriate rating standards. Voltage and current requirements are listed on the license
label, located at the back of the projector.
• On power down, wait 5-10 minutes for the fans to turn off before unplugging the projector. Always
switch off the projector before unplugging the AC line cord.
1. Connect the projector line cord to the AC receptacle at the AC inlet of the projector.
2. Push the wire clip over the plug to retain it. This prevents the line cord from inadvertent
disconnection.
3. Plug the three-pronged plug end into a suitably rated grounded AC receptacle.
4. Switch the projector ON. The switch is located just above the AC receptacle.

Powering on the projector

After the AC Power has been switched on, the LCD display above the keypad indicates Please wait
and the four LED status indicators on the top cover window switch on to amber. These indicate that
the projector is changing its state from powered down to standby. The message Standby Mode
appears in the display when the projector has completed its initialization and is ready for power up.
Mirage M Series User Manual
020-101942-02 Rev. 1 (10-2018)
http://www.pureglare.com.au
Connection
Connect a single or dual DVI video signal to the DVI-I connector, an analog
video signal to the DVI-I connector, or an analog video signal to the VGA
connector. The DVI signal may contain HDCP (High-Bandwidth Digital Content
Protection).
Connect HDMI (High-Definition Multimedia Interface) cable to one of the two
inputs, 1-IN or 2-IN.
Depending on the source you can apply the following;
• Composite video source to 1-CVBS, using a BNC Cable — the same signal can
be used on 4, 5, or 6 when input is selected as CVBS.
• A component signal on Inputs 4(Pr), 5(Y), 6(Pb) using BNC Connectors —
grouped as a component input, YPbPr,
• S-Video to one of the two, 2-SVID or three-SVID using S-Video cable.
• S-Video using two BNC cables, with Luma (Y) connected to 4 (Sy) and
Chroma (C) connected to 6 (Sc) — must be grouped as one S-Video + one
CVBS.
Has two 5pin XLR connectors - one (input) male and one (output) female. If
there is active communications on the DMX512 Interface card the power LED
will blink between low intensity and high intensity.
Accepts DisplayPort 1.1a inputs from one or two DisplayPort sources.
on page 44 for more details.
Installation and Setup
32