Editing A Channel Setup; Auto Source; Locked; Previous Channel - Christie Roadster User Manual

Operation
Editing a Channel Setup 
CHANNEL EDIT — STEP 1
CHANNEL EDIT — STEP 2
CHANNEL EDIT — STEP 3
3-22
The basic setups that describe how and where a channel can be accessed are listed in
the Channel Setup menu. These channel setups can be edited at any time in the
Channel Edit submenu.
From the presentation level press
Channel Setup menu, press
and press . The Channel Setup menu will appear.
Enter
To edit parameters shown in the Channel Setup menu, select the relevant channel and
press . The Channel Edit menu will appear similar to the sample shown in Figure
Enter
3.13.
Figure 3.13. Channel Edit Menu (
If desired, review and/or edit the following channel setups in the Channel Edit menu:

An alpha-numeric label can be defined and/or changed here.
CHANNEL NAME:
Channel names can be up to 12 characters in length.

A two-digit channel number can be changed here.
CHANNEL NUMBER:
NOTES: 1) If you enter a channel number that already exists, a dialog message
appears indicating that this number is already in use–assign a different channel
number. 2) You can define 50 channels.

1-8, corresponding to where on the projector's input panel the source is
INPUT:
connected.

If checked (default, except for automatically defined channels with
IN MENU:
unchanged parameters), this defined channel will then appear in the list available
key is pressed. If unchecked, the channel must be accessed via the
when
Chan
channel setup menu
Menu
NOTE: On-screen display of the channel list is an option that must be set in the
Menu Preferences menu.

If checked, (default), the projector can automatically locate this

AUTO SOURCE:

channel when an incoming input signal matches. If not checked, the projector can
locate the selected channel only when it is directly selected via
keypad—and a change in input signal will not result in a channel change.

If checked, all of the image settings for this channel are disabled. If

LOCKED:

unchecked (default), all available image settings can be adjusted as desired. You
cannot use Auto Setup with a locked channel.


PREVIOUS CHANNEL:

for the previous channel in the Channel Setup list.
to display the main menu. To display the
Menu
, or move the highlight to the Channel Setup option
on the keypad or via the Auto Source function.
Select this option to see or change Channel Edit settings
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
)
SAMPLE
on the
Chan
020-100002-05 Rev. 1 (02-2010)