Configuring Up The Lamp; Selecting The Lamp Operation Mode; Selecting The Lamp Mode - Christie Mirage M Series User Manual

• Manual Zoom/focus—When this control is selected, the holding current is removed
from the zoom and focus motors so that they can be changed manually. Zoom and Focus
should not be adjusted manually when this control is not selected, as this results in
damage to the motors.
• Calibrate—The lens calibration procedure is needed each time a new lens is installed in
order for the ILS feature to perform reliably. This procedure calibrates; horizontal,
vertical, focus, and zoom offset movements.
• Lock All Lens Motors—Prevents all lens motors from moving. It disables the Zoom,
Focus, Horizontal and Vertical Position settings, effectively locking out any changes and
overriding all other lens features. This prevents accidental lens position changes in multi-
projector installations.
• Calibrate On New Lens—Prompts for a lens calibration each time a lens is inserted.
The user is always prompted before starting the calibration.
• Calibrate On Startup—Check this box to initiate a 'Lens Reset' procedure on every
power-up. Use this if the lens is subject to manual movement between power sessions.
• Home Position—Return the lens to the horizontal and vertical home position. Focus and
zoom are unaffected.
• Calibration Status—Displays the current lens calibration status.

Configuring up the lamp

Selecting the lamp operation mode

Select between one of the following lamp operational modes in Lamp > Lamp Operation:
• Lamp 1 single lamp use or Lamp 2 single lamp use modes only use the lamp specified. If
the selected lamp does not strike, the projector does not turn on.
• Dual Lamp Use mode uses both lamps together. The projector stays in this operational mode
even if only one lamp successfully ignites. If both lamps fail to ignite, the projector goes back to
standby.
• Auto-Select a Single Lamp mode ignites the lamp with the fewest recorded hours of on
time.

Selecting the lamp mode

Select between one of the three different lamp modes in Lamp > Lamp Mode:
• Maximum Brightness mode sets the lamp to run at its highest power level.
• Constant Intensity mode maintains a specific brightness level over time. The brightness level
can be adjusted with the Intensity control (see below). As the lamp ages, the projector
increases power to maintain the desired brightness. This option is disabled if LiteLOC calibration
has not been performed.
Mirage M Series User Manual
020-101942-02 Rev. 1 (10-2018)
http://www.pureglare.com.au
Operating the projector
68